Specifications:
– Volume: approx. 10 liters
– Interior: 350L x 140H x 210D mm
– Exterior: 578L x 238H x 356D mm
– Liquid level min./max.: 97/120 mm
– Working temperature range: min. 5 0 C above ambient to 95 0 C with additional boiling stage.
– Temperature variation: ± 0.10C
– Temperature distribution: ± 0.250C
– Controller: digital display (LED) of all set parameters, such as temperature and alarm values (0.1 0 C resolution) as well as time values
– Timer: digital timer from 1 min. up to 999 hours for: ON (continuous operation), DELAYED ON, HOLD or HOLD set-temperature dependent with guaranteed holding time.
– Temperature sensor: 2 Pt100 sensors Class A in 4-wire-circuit, mutually monitoring and taking over the performance at the same temperature value
– Temperature control: mechanical temperature limiter TB protection class 1 switching the heating off at approx. 300C above max. temperature of the bath
– Temperature control: independently working, electronic overtemperature controller TWW protection class 3.1 or overtemperature limiter TWB protection class 2, adjustable in set-up menu by customer
– In case of overtemperature due to failure, the heating is switched off at approx. 10 0 C above the set temperature (fixed value)
– Autodiagnostic system: fuzzy-supported PID microprocessor controller with integrated autodiagnostic system with fault indication
– Alarm: visual and acoustic alarm at programme end and as input acknowledgement as well as in case of low liquid level, heating is switched off automatically
– Heating baths: corrosion-proof large-area heating on three sides
– Interior: easy-to-clean interior, made of stainless steel, reinforced by deep drawn ribbing, material no. 1.4301 (ASTM 304), laser-welded
– Stainless steel exterior
– Voltage: 230 V, 50/60 Hz
– Electrical load: approx. 1200 W (during heating)
– Installation: The vent openings in the left and back side must remain unobstructed The distance to the wall must be at least 100 mm on the sides. The minimum spacing from the top of the bath to the next ceiling is 750 mm.
– Ambient temperature: +5 0 C to 40 0 C
– Humidity: max. 80% RH, non-condensation
Options:
+ Stainless steel gable cover, code: B02642
+ Flat stainless steel cover with concentric ring sets for ring set openings: 3 openings / 107 mm diameter, code: B02681
+ Flat stainless steel cover with concentric ring sets for Peltier cooling CDP115: 3 openings / 107 mm diameter, code: B24373
+ Peltier cooling device, CDP115
+ Installation and conection set for Peltier cooling device CDP115 (including mounting bars for all different bath sizes), code: B02770
+ Calibration at Memmert factory for a temperature value: 37 o C, code: D00123
+ IQ/OQ documents, code: D00125
